Manne Guitars - Components page

Guitar Pick-ups

Manne blades Minihumbuckers ed Humbuckers
They are wound by hand directly on the blade instead of on bobbins. This gives the pickup extraordinary sensitivity to playing nuances. The tone is more "musical" and highlights your touch with great dynamic extension.
The two coils can be connected in serie or parallel giving you two calibrated sounds: the fatter and warm sound when in serial connection and a brighter sharper sound when in parallel. Compared to the usual split/coil, the serie-parallel always use both coils, so it will always perform noise cancellation, being in humbucker mode on both connections.

"The best sounding pick-ups I've ever heard!"
Marc Cooper, dimostratore americano Digitech.

"Your Manne Blades MiniHumbucker is a beast! Cuts through the mix like nothing."
Horst Keller, dimostratore tedesco Line6

Humbuckers LBD		front	rear
Resistance		8.0K	9.36 K
Inductance		2,2 H	2,0 H
Reference tone chart:		signal	signa
Bass	80hz	15	12
Mid low	500hz	9	10
Mid	1khz	9	10
Mid hi	2khz	8	8
Treble	8khz	8	10

Minihumbuckers SBD
Resistance	11.7K
Inductance	2.3 H
Reference tone chart:		signal
Bass	80hz	10
Mid low	500hz	10
Mid	1khz	10
Mid hi	2khz	10
Treble	8 khz	8

Single vintage alnico V

D.C. Ohm: 6,20K
Inductance (L): L3,19

Reference tone chart:	signal
Bass	10
Mid low	8
Mid hi	10
Treble	10

Disponibile in versione bianca per i modelli Raven

SB Pickups for 7 - up to 10 strings

These humbucker pickups are ideal to cover the tonal response of instruments from 7 strings up to 10 strings. The bar polar expansion let the be suitable to any strings spacing. The two coils can be connected in series or parallel.

We developed a specific preamp to work specifically in conjuction with these pickups to let them work in standard ceramic classic tone and output or let them increase the volume output and frequency range to let them sound more like classic active pickups.

Guitar Bridges TOP HARDWARE
W		W Wilkinson Bridge: VG300 with steel saddles, base and block. 2 screws pivots. Steel bended saddles add a "sparkle" to sound of this bridge. Finish: Chrome
LPM		- Manne Stop tailpiece Handmade by Manne T.L.M. guitar hardware. In crude, cold rolled steel. - Manne tailpice screws, modified to screw the tailpiece firmly againt the body top to optimize the sound transmission. - Manne bridge lock enable to lock the bridge at his position securing it to the screws and optimizing sound trasmission. Istruzioni Finish: Chrome and Cosmo Black
FG		FG Floyd Gotoh Bridge We start using this bridge since its introduction, 1996, that's where its code name comes from. We consider it a superior floyd, superion in material, and in tone as it is less metallic and less tone killing than other floyds. Available just in cosmo black finish
NT		NT6 Manne nontremolo bridge for 6strings handmade by Manne T.L.M. guitar hardware developements. In crude, cold rolled steel NT7 Manne nontremolo bridge for 7 strings handmade by Manne T.L.M. guitar hardware developements. In crude, cold rolled steel NT8 Manne nontremolo bridge for 8 strings handmade by Manne T.L.M. guitar hardware developements. In crude, cold rolled steel

Guitar Bridges STANDARD HARDWARE
LP		LP Standard Bridge Top construction and classic features and sound. - Manne customized standard stop-tailpiece is modified to let it lay flat on guitar body - Manne tailpice screws, modified to screw the tailpiece firmly againt the body top to optimize the sound transmission. Finish: Chrome and Cosmo Black Also available LP7 for seven strings
ST		WA Wraparound Bridge Lightweight and with fine compensation adjustments. Finish: Chrome
F		F Bridge Floyd Rose Double Locking, thick Casting plate, Licensed under Floyd Rose Fingertip arm tension adjustment - fine tuner Plain-end string mounting 43.0 m/m locking nut Die-cast Base plate with Hardness pivot-edge inserts Include arm, locking nut, studs, bushings, springs, spring claw hook and allen wrenches. Available just black Finish: Black
F7		F7 Bridge Floyd Rose Double Locking Casting plate, Licensed under Floyd Rose Fingertip arm tension adjustment - fine tuner Plain-end string mounting 43.0 m/m locking nut Die-cast Base plate Include arm, locking nut, studs, bushings, springs, spring claw hook and allen wrenches. Finish: Black
SV		SV Bridge Standard vibrato with steel saddles and aluminum block. Good, consistent tone. Increased tuning stability due to side saddle positioning borders. Available just chrome. Finish: Chrome
TV		TV Wilkinson WV6 SB 5+1 unique wilkinson knife edge system to get from the 6 pivot set-up its best. Vintage style and sound. Solid steel sustain block. Finish: Chrome
TL		Tele Bridge classic Finish: Chrome
WV		Contemporary wilkinson WVP SB Finish: Chrome

Bass Pick-ups
B	MANNE BLADE Pick-ups JHR They are wound by hand directly on the blade instead of on bobbins. This gives the pickup extraordinary sensitivity to playing nuances. The tone is more "musical" and highlights your touch with great dynamic extension. The two coils can be connected in serie or parallel giving you two calibrated sounds: the fatter and warm sound when in serial connection and a brighter sharper sound when in parallel. Compared to the usual split/coil, the serie-parallel always use both coils, so it will always perform noise cancellation, being in humbucker mode on both connections.	Bass Minihumbuckers JHR N (neck): R: 6,64K - I: 5,2H; B(bridge): R 6,76K - I: 4,7H
J	Used on: Trea	J-CD (covered) model Powerful Alnico Jazz bass sound Pole-Pieces type : Fixed Magnet : Alnico rod Bobbin : Fiber materials Cable : Two conductor cloth Edge cutting : Yes 4 strings bridge D.C.Ohm(k) : 7.95, Inductance(L) : 3.57, Pole pieces Spacing : 19.4 m/m Tone chart(Low):10,(mid-low):11 (mid-high):11, (high):9 4 strings neck D.C.Ohm(k) : 7.60, Inductance(L) : 3.44, Pole pieces Spacing : 18.6 m/m Tone chart(Low):10,(mid-low):11 (mid-high):11, (high):9 5 strings bridge: D.C.Ohm(k) : 6.65, Inductance(L) : 3.63 Tone chart(Low):10,(mid-low):11 (mid-high):11, (high):9 5 strings neck: D.C.Ohm(k) : 6.45, Inductance(L) : 3.53 Tone chart(Low):10,(mid-low):11 (mid-high):11, (high):9
S	Used on: Moab and Newport with MM humbucker	S Model We use this pickup just in neck position Powerful Cermic Jazz bass sound Fixed pole pieces Single coil wiring Fiber material bobbin Ceramic Magnet Bar Pole pieces Spacing : 16.8 m/m Two conductor with shield 200 m/m length 4 strings: Pole-Pieces type : Fixed D.C.Ohm(k) : 3.97, Inductance(L) : 3.59 Tone chart(Low):11,(mid-low):10 (mid-high):10, (high):11 5 corde: D.C.Ohm(k) : 5.25, Inductance(L) : 5.42 Tone chart(Low):11,(mid-low):10 (mid-high):10, (high):11
PJ	Used on: Soulmover, Moab	PJ Model We use this pickup just in neck position Powerful Cermic Jazz bass sound Fixed pole pieces Single coil wiring Fiber material bobbin Ceramic Magnet Bar Pole pieces Spacing : 16.8 m/m Two conductor with shield 200 m/m length 4 strings: Pole-Pieces type : Fixed D.C.Ohm(k) : 3.97, Inductance(L) : 3.59 Tone chart(Low):11,(mid-low):10 (mid-high):10, (high):11 5 corde: D.C.Ohm(k) : 5.25, Inductance(L) : 5.42 Tone chart(Low):11,(mid-low):10 (mid-high):10, (high):11
MM	Used on: Moab and Newport	MM model Pole-pieces type : Fixed Magnet : Alnico rods Bobbin : Fiber materials Cable : Four conductor with shield Bottom plate : N/A Position : Neck and Bridge 4 strings: D.C.Ohm(k) : 4.66, Inductance(L) : 1.98 Tone chart(Low):12,(mid-low):11 (mid-high):11, (high):14 5 strings: D.C.Ohm(k) : 5.80, Inductance(L) : 2.34 Tone chart(Low):12,(mid-low):13 (mid-high):13, (high):14 6 corde: D.C.Ohm(k) : 6.12, Inductance(L) : 2.55 Tone chart(Low):14,(mid-low):13 (mid-high):13, (high):14
SB	Used on: Acoustibass or on request on Moab	SB Humbuckers BT4 / BT5 / BT6 Powerful Ceramic sound Hum cancel wiring Ceramic Magnet Bar Maximum string Spacing : 4 strings: 90.00 m/m 5 strings: 91.75 m/m 6 strings: 79.00 m/m

Bass bridges
M	Used on: Moab ,Trea, Mojave, Newport Special and Soulmover Active.	M Manne Bass bridges Available for 4 strings (gold, chrome and black), 5 strings (chrome and black) and 6 strings (just black). The saddles has hardened material, 3D adjustable and lockable. Solid Brass body. Is possible to have string thru the body or standard. Original string entrance groove. This bridge enanches harmonics and sustain. It gives a better transmission of vibrations to the body of the instrument. Finish: Chrome and Cosmo Black
P	Used on: Acoustibass	P Manne Piezo bridge aluminum body with brass saddles. saddles gives indipendent pressure on piezo and are precisely build to match our fingerboard radius specification. Available for 4, 5 or 6 strings.
T	Used on: Newport satin, Malibu 5	TC Classic Bass bridge Available for 4 and 5 strings Finish: Chrome
W4		Wilkinson WBBC Perfect reproduction of vintage barrel bridge style with Brass saddle. On 4 strings Malibu Finish: Chrome
I		Individual Bass saddle Finish: Chrome

A		3-band active/passive switchable (at the volume push/pull), balance-pot with dip in center-position, treble-pot in active mode +/- 18 dB@18 KHz, in passive mode acting as classical highcut, bass +/- 14 dB@40 Hz, mid +/- 9 dB@550 Hz, battery-connection 9 volts. Due to the high performance electronic, in flat position of the eq you can hear no difference between active and passive mode!
		with Blades pickups we use the combined electronics of 3tone switches and glockenklang active elecrtronics 3tone switch: - serie: hot humbucking, hi-output, strong mids - parallel: normal, similar to single coil sound, but without hum. - split: V-shape frequency response, similar to an active, with crisp hi-frequencies. Funk with two pickups combined.
		with soapbars or MM pickups
		TREA Circuit

Guitar tuners TOP HARDWARE
TMG	Used on: TAOS together with the Gotoh VG300	Meccanica Manne Autobloccante Finiture: Chrome and Cosmo Black

Circuit for guitar
P	Volume, tone, selector.	Volume pushpull for series/parallel on neck pick-up and Tone push pull for series/parallel on bridge pickup